swimming pool maintenanceEven the best swimming pool maintenance approach would not be enough for storms. Storms with strong winds and heavy rain, like hurricanes, can sweep dirt and debris into your pool. Storms that cause flooding can bring more contaminants, such as bacteria, silt and mud.

It can be difficult to keep your pool safe and clean in normal circumstances. Cleaning it using swimming pool supplies can be more difficult in severe weather conditions. You have probably made all the necessary preparations for the storm to your swimming pool. We are also available to assist you. These are some easy tips to bring your pool back into its original state and make it crystal clear again.

Swimming Pool Maintenance Tips

Do Not Drain Water from Your Swimming Pool

You must not drain all the water from your swimming pool, even if it is clogged with debris. This is the first tip for swimming pool maintenance Myrtle Beach. Although it may seem trying to drain your swimming pool as well as start over using clean water, it can cause your swimming pool to float off the ground or burst due to increased water table. It is better to get rid of any pool water as soon as possible, regardless of its condition.

Remove Leaves and Debris from the Pool Surface

After a storm, you need to remove any debris or leaves that have settled on the bottom of your pool. It’s one of your responsibilities after swimming pool installation. To remove leaves and debris from the pool, use a leaf net or a skimmer equipped with an extendable pole. Due to the large amount of debris in the pool, you will need to regularly clean the skimmer basket. The small particles of dirt can be brushed off later in the cleaning process.

Clean the Skimmer Baskets and Pump Strainers

It’s important to clean the skimmer baskets as well as the strainer before you turn on the filtration system. They will become clogged with debris, and if they aren’t cleaned up properly could cause system to stop working.

Restore Power and Check Electrical Device

You must first remove any plastic covers and inspect for signs of water damage before you turn on the power. It’s okay to turn on the power if the equipment is clean. Then, you can start running your circulation and filtration systems. If the equipment is showing signs of water damage, or water itself, don’t turn it off.

Clean the filter and then backwash it

The filter must be cleaned and then backwashed due to the high amount of dirt and dust in the water. This will also need to happen depending on how severe the storm was. When cleaning the filter and backwashing it, make sure you read the operator’s manual.

Check the level of the water and remove as much water as you need. Your swimming pool may be filled with a lot of rainwater during a severe storm. It’s okay. This simply means you will need to remove excess water from the system and return it to its original level with a siphon.

Vacuum and brush the pool walls and floor

Once you have turned on the pool equipment, and restored the water level to the desired level, it is time to clean the pool of any dirt and dust particles. Use an automatic pool cleaner to vacuum the dirt and debris from the bottom.

Shock Water and Balance Pool Water Chemistry.

Although your pool might appear clean, there may still be harmful organic contaminants. You will see algae growth if they are not addressed. Use a strong pool shock to prevent this. You can add sufficient shock to increase the level of chlorine to approximately 10.0ppm.

The Water Filtration and Circulation System Must Be Operated Until Clear

After a storm, run the filtration system and circulation system until you have a clean and clear pool. This could take several days. You should ensure that the system runs continuously.

If you have any questions about maintaining your pool, call Elko Spas Billiards & Pools.

Elko Spas Billiards & Pools
4718 Northgate Blvd
Myrtle Beach, SC 29588
(843) 294-3556
spasbilliardspoolsmyrtlebeach.com